Channel 2 Tx event configuration register
TX_LIM_CH | This register is used to configure the maximum entries that CHANNEL%s can send out. |
TX_LOOP_NUM_CH | This register is used to configure the maximum loop count when tx_conti_mode is valid. |
TX_LOOP_CNT_EN_CH | This register is the enabled bit for loop count. |
LOOP_COUNT_RESET_CH | This register is used to reset the loop count when tx_conti_mode is valid. |
LOOP_STOP_EN_CH | This bit is used to enable the loop send stop function after the loop counter counts to loop number for CHANNEL%s. |